10
OPERATING SEQUENCE
1. Make sure that the unit has power (Main LED should be
G R E E N
.)
2. Using the Electrical Vehicle Charging Cable, connect the unit to the electric vehicle suitable SAE J1772
TM
inlet connector.
3. Once connected, the Main LED should light up briefly
Y E L L O W
before going to
B L U E
.
4. The Main LED will stay lit in the
B L U E
color during the charging sequence. For certain vehicles, the Main LED will light up
Y E L L O W
once the charge is completed.
5. If the Main LED becomes
R E D
once connected to the electric vehicle, but gets back to
G R E E N
once the charging cable is disconnected, this means that
charging this model of electric vehicle requires ventilation if done in an indoor location. Our charging unit isn’t compatible with these vehicles. So, make sure
to check with your electric vehicle manufacturer to be certain that our charging unit can charge your specific electric vehicle.
6. When the charge is finished (or when the user wants to terminate the charge), simply disconnect the SAE J1772
TM
connector from the electric vehicle by
pressing the release button on the SAE J1772
TM
connector.
7. Replace the Electric Vehicle Charging Cable on the unit as shown in Figure 2.1
The Main LED on the front of the unit indicates the state of the unit.
This table summarizes the possibilities for the colors of the Main LED.
State of the Main LED
Color
Description
Green - Constant
The unit is powered up and is ready to accept a vehicle connection.
Yellow - Constant
A vehicle has been detected but it isn’t ready to accept the charge
(This state happens very briefly after vehicle connection).
A vehicle has been detected and the charge is completed
(certain vehicles only).
Blue - Constant
The vehicle is connected and is in charging state.
Red - Constant
Indoor charging area ventilation required.
No charging allowed.
The unit is in fault mode. Check the troubleshooting table.
Never operate
the unit if the enclosure
isn’t sealed.
