10
BARCODE ENABLE
*OFF ON
CARD READER ENAB
*OFF ON
CARD READER TYPE
MSR *HCR CRT
CARD TRACK
2
BARCODE ERR. NO.
10
BARCODE ENABLE
This option allows you to enable (ON) or disable (OFF)
the barcode identification on the tickets inserted. With
the UP e DOWN buttons you move the asterisk (*) and
press ENTER. Setting this option ON the machine will accept only tickets with
barcode equal to the saved one.
CARD READER ENABLE
This option allows you to enable (ON) or disable (OFF)
the card reader on the machine. With the UP and
DOWN buttons, move the asterisk (*) and press
ENTER. If disabled, the card reader won’t be tested when the machine is
turned ON, and it could work even without the card reader.
CARD READER TYPE
This option allows you to program the type of card reader installed in the
machine, it is programmed in factory and does not need to be changed except
in case of a replacement of the reader or the
motherboard. With the UP and DOWN buttons move
the asterisk (*) and press ENTER.
CARD TRACK
This option selects, between the 3 possible solutions, the magnetic track of the
card that will be used. With the UP and DOWN buttons
set the number and
press ENTER.
Normally the track used is the number 2, it could be
changed only if the card used is also part of another information system that
used the same track.
BARCODE ERROR NUMBER
This option sets the number of consecutive errors of
tickets barcode reading before that the machine will
block itself and indicate the error. With the UP and
DOWN buttons, set the desired value and then press ENTER.
