Elma ELMA-1336, Instruction Manual

Page: 14 / 29

12
step 5-4-1.
2. When the display shows measurement result that you feel are satisfactory for
use as your target values, press H key to hold these results.
3. Press Tcp key to enter the correlated color temperature difference
measurement mode. If you have previously set a target, the display shows
the difference between the new measurement and this previously set target.
4. Press SET key to enter the SET mode, the annunciator
“
SET REF
” and
the measurement result that you held at step 2 above now blink on the
display. If you wish to cancel without store the blinking values as your new
target, press SET key again.
5. Press

key to store the measured value into the target memory, so that they
become the current target values. The displayed values accordingly change
“+0.0” (Where the number of digits on each line varies according the display
mode), since the measured values and target values are now identical.
6. Press H key again to exit Hold mode and back to the correlated color
temperature difference measurement mode. In this mode, you can review
the target values at any time by holding down the

key. The values
remain on the screen until you release the key.
5-4-2-2 Manually keying in the target values
1. Press Tcp key to enter the correlate color temperature measurement
mode. The display shows the measurement results.
2. Press Tcp key again to enter the correlate color temperature difference
measurement mode.
3. Press SET key to enter the setting target values mode, the annunciators
“
SET REF
” and the previously set target values are displayed. If no target
is currently set, the display shows o
’s for all parameters.