OPENS
Range of open detection : 0 to 350m (0 to 999ft)
Accuracy of distance to an open :
UTP/FTP : 10% + 1m (10% + 3 ft)
SPLIT PAIRS
Range of detection : 2 to 350m (6 to 999ft)
Split pair part of the cable must be at least 2 meters (6ft) in
length and greater than 10% of the total cable length.
COAX Termination Measurements
Any loop resistance value between 5 and 350
Ω
is
interpreted as a termination resistance. Resistance value
below 5
Ω
is considered shorts and resistance value
greater than 350
Ω
is not displayed.
General Specifications
Power : Six AAA size 1.5V batteries.
Low Battery Indication : Display shown “
+
”.
Battery Life : 100 hours.
Auto Power off : 5 minutes, (When there is no key activity).
Remote Cable Identifiers : #1 (#2 to #4 and #5 to #8 are
optional).
Input Protection : 50V DC.
LAN Input Connectors : RJ45, BNC.
Environinental Conditions :
Operating : 0 to +40
℃
< 80%RH / Storage : -20 to +60
℃
<
70%RH
Dimensions : Cable Tester 150 x 72 x 35mm
Remote identifier 60 x 23 x 22mm
Weight : Cable Tester 215g / Remote identifier 35g
IV.
SETUP SELECTIONS
The setup mode allows to select and calibrate cable
characteristics.
Once changed, these settings are stored and remain in
the tester even when tester is turned off.
Setup items :
Select cable type ( UTP, FTP or COAX ).
Select a cable category.
Select a wire size.
Calibrate cable length.
Enable or disable the Beeper for ON (PASS) and OFF (FAIL).
Setup procedure :
1. Press SET key.
2. Press
enter key to set up through the selections.
3. Press ▼ ▲ keys to select the desired setup condition.
4. Press
enter key to store the setting and move to the next
setup selection, or press SET key to exit the setup mode.
Power–up selection :
Select length measurement units
between feet
( ft ) and meters (m).
Power–up setup procedure :
1. Turn off the tester, press and hold down LENGTH key, then
press and hold down power key, until display show “
”.
2. Press ▼or ▲ keys to the desired length units.
3. Press
enter key to store the unit (ft/m) and exit this mode.
