Elliott Roto-Jet II 0650, Operating And Maintenance Instructions Manual

Page: 18 / 26

18
Roto-Jet II
MaInTenanCe InsTRUCTIOns
Before Each Use
1. Inspect your Roto-Jet II® for any obvious damage or missing parts.
2. Check the power cord for cracks or wear.
3. Test the GFI plug to insure proper functioning.
4. Inspect the manifold o-ring. Replace if necessary.
5. Make sure the filter washer is in place and clean.
6. Inspect the foot switch air hose(s) for damage.
7. Check the fuse, replace if necessary.
8. Tighten all screws and bolts.
9. Make sure all the vents cut in the machine casing are clear.
10.
Briefly test run your Roto-Jet II®.
a.) If abnormal noise or vibration occur, turn the machine off immediately.
b.) See the “Trouble Shooting” section to diagnose the problem and correct the
problem before further use.
After Each Use
1. Disconnect the flexible shaft from the unit and drain the water from the casing.
2. Spray a water displacement solution such as WD-40 into the casing from both ends,
allowing the solution to run the entire length of the shaft.
3. Coil the flexible shaft in a large diameter coil and tie it with the supplied Velcro strap.
4. Disconnect the footswitch and safely store.
5. Coil the power cord and tie together.
Long Term Storage
1. Drain excess water from the flexible shaft casing.
2. Generously spray a water displacement solution such as WD-40 into the casing from both
ends, allowing the solution to run the entire length of the shaft.
3. Store the flexible cable in large diameter coil and tie them with the supplied Velcro strap.
4. To prevent freezing or other resultant damage, clear the manifold of water.
a.) Activate the solenoid by depressing the foot switch.
b.) Force compressed air through the garden hose fitting. The air will remove most of
the water from the manifold.
5. Disconnect the foot switch and safely store.
6. Coil the power cord and tie together.
7. Safely store the Roto-Jet II® and the accessory items for the next cleaning season.