page 8
11. Light Kit Assembly (Optional).
switch housing cap
bulb
[
representative only
]
center cap
motor housing
switch housing cap
switch housing
diagram a
diagram b
blue wire
white wire
hex nut
lock washer
WARNING:
Failure to disconnect power
supply at main panel prior to light kit assembly
may result in serious injury.
If you wish to use your fan WITH a light kit
(sold
separately), r
emove 3 screws from switch housing.
Remove switch housing cap from switch housing.
(Refer to
diagram a
.)
Locate
BLUE
and
WHITE
wires in the switch
housing labeled FOR LIGHT. Remove and discard
cardboard label and plastic that hold these 2 wires
together. Remove wire connectors from these same
wires as well--
save for later use
. (Refer to
diagram a
.)
Remove hex nut and lock washer from threaded
rod on light kit fitter. Punch center cap out of
switch housing cap with a screwdriver. Push wires
from light kit fitter through hole in middle of switch
housing cap and screw switch housing cap onto
threaded rod followed by the lock washer and hex
nut that were previously removed. (Refer to
diagram b
.) Tighten hex nut over lock washer for a
secure fit.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from switch housing. Connect
BLACK
wire
from light kit fitter to
BLUE
wire from switch
housing. When making the connections, use wire
connectors that were previously removed.
Note
: Wrap each wire connector separately with
electrical tape as an extra safety measure.
Align holes in switch housing cap with holes in
switch housing. Re-insert screws that were
previously removed and securely tighten all 3
screws.
Attach glass shade(s) to light kit fitter using the
hardware provided with the light kit. (Refer to
diagram c
.)
Note
: If you are installing a bowl fixture, the bulb(s)
must be installed first.
Install bulb(s) specified by the light kit.
If you are
installing a halogen bulb, be sure not to handle glass
directly with your fingers as oil from the skin may
shorten the life of the bulb.
Important
: When changing bulb(s), remember to
allow bulb(s) and glass shade(s) to cool before
touching them.
glass shade
[
representative only
]
light kit fitter
[
representative only
]
light kit fitter
[
representative only
]
diagram c
switch housing cap
wire connectors