7. Wiring.
page 6
8. Canopy Assembly.
canopy
slotted
hole
hanging bracket
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket align
with
slotted
holes in canopy, and then lower canopy
and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws and secure all screws with Phillips
screwdriver.
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
*
from ceiling
from fan
ground
(green or bare)
black
black
white
white
blue
black supply wire
white supply wire
*
from ceiling
from fan
ground
(green or bare)
Important
:
Be sure outlet box is properly grounded and that a
ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to below, please use a
qualified electrician.
When downrod is secured in place on the hanging bracket,
electrical wiring can be made as follows:
Connect
BLACK
wire from fan to
BLACK
wire from ceiling
with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from ceiling
with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from fan to
BARE
/
GREEN
wire from ceiling with wire connector
provided.
Since this fan does not come with a light kit, you will need
to cap off the
BLUE
wire with a wire connector (as shown
with arrow).
If you elect to purchase a light kit for the fan
, electrical
wiring can be made as follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire
from ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from ceiling
with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from fan to
BARE
/
GREEN
wire from ceiling with wire connector
provided.
Wrap each wire connector separately with electrical tape as
an extra safety measure.
If you intend to control the fan light with a separate light
switch, connect
BLUE
wire from fan to the
BLACK
supply
from the independent switch.
This fan is remote control adaptable (remote control sold
separately).
ground
(green
or bare)