ELKO - SmartMove Multiwire Dimmer Push
Resetting the device
You can reset the device to factory default manually.
To reset the device:
1. Short press push button 3 times (< 0.5 s) and then long press the push button
once (>10 s).
2. After 10 s, LED starts blinking red then release the push button.
The LED stops blinking upon successful reset of the device.
3. The Motion Sensor Dimmer restarts and blinks green for a few seconds.
NOTE:
After reset, the LED turns amber indicating that it is ready for
pairing.
Using the device
The Control Panel allows you to switch the device On/Off, increase/decrease the
brightness and control various settings.
On the
Home
page, tap
All devices
>
Motion Sensor Dimmer
to access the
control panel.
On the control panel page, you can see the following:
•
The motion detection and current Lux level (A)
•
The current device state and brightness level (B)
•
Sliding bar to adjust the brightness (C)
•
(D)
•
(E)
Motion Dimmer
On 50%
60
A
D
E
B
C
3× < 0,5 s
+1× > 10 s
16
DUG_SmartMove MW Dimmer_ELKO-00
Summary of Contents for EKO07253
Page 4: ......
