Elko EKO07253, User Manual

Page: 12 / 30

ELKO - SmartMove Multiwire Dimmer Push
Managing motion sensor dimmer settings
Using The ELKO app, you can manage the settings.
Follow the steps to access the motion sensor dimmer settings:
1. On the Home page, tap All devices > Motion Sensor Dimmer .
2. On the device control panel page, tap Settings .
Dimmer setting
Dimming Mode
You can change the dimming mode in the app if you have problems with light
flickering. This improves the dimming quality.
Tap Dimming Mode and select either of the following (A):
– Auto - When any other load is connected to the dimmer (e.g. filament bulb)
– RL-LED - Select the mode only when the LED is not working properly in Auto
mode
NOTE: Refer to technical data, page 28 for more information.
Settings Settings
A
Dimming Range
You can restrict the maximum and minimum brightness of the load connected to
the device. This is done to avoid flickering and switching off the LED.
Tap Dimming Range and do either or both of the following (B):
– Min Brightness - Drag the slider bar to restrict the minimum brightness
NOTE: The minimum brightness level should be lower than maximum
brightness level.
TIP: If you set the minimum brightness to the right most position on this slider
bar, then the load glows at this minimum brightness value even when you drag
the sliding bar in the control panel to the bottom most position (for more
information refer to
control panel, page 16 ).
– Max Brightness - Drag the slider bar to restrict the maximum brightness
NOTE: The maximum brightness level should be greater than minimum
brightness level.
TIP: If you set the maximum brightness to the left most position on this slider
bar, then the load glows at this maximum brightness value even when you
drag the sliding bar in the control panel to the top most position (for more
information refer to
control panel, page 16 ).
12 DUG_SmartMove MW Dimmer_ELKO-00