15
1.
RF Receiver/Control Module Settings
Remove the cover from the RF receiver/control module. SW4 (Figure 10) allows this board to be
used in different product applications. The firmware has been programmed such that SW4 rotary
position has no affect programming, so the dial should remain in position 1.
Figure 10
24263001 Receiver Layout
Caution:
Do not change switch A position 1 switch position. This switch is used to set the
priority setting of the transmitter and changing this switch may remove override capabilities.
2.
81282001 Handheld RF Transmitter Settings
a)
Remove the battery cover from the handheld RF transmitter. Remove the four screws holding
the two halves of the cover together using a #1 size Pozidriv
screwdriver (use caution with a
standard Phillips screwdriver as it may eventually strip the heads of the screws).
b)
Locate the security code switches on the transmitter circuit board (Figure 11).
c)
Change the switches to match the settings of the RF Receiver/Control Module except switch
A1. One incorrect setting will prevent the system from working.
d)
Ensure the battery lead connector is securely fastened to the transmitter circuit board.
e)
Check that no wires will be pinched, close the cover halves and replace the screws. Do not
exceed 6 in-lbs of torque. The screws should just be snug, do not over tighten the screws, or the
plastic enclosure could strip.
Caution:
Do not change the switch A position 1 on any transmitter. This switch is used to
set the priority of the transmitter and changing this switch may remove override capabilities.
SW4
