4
CobraMax Installation
Reference the CobraMax Kit Parts Drawing on
for more detail on parts used.
1. Position the monitor so that the discharge is pointed straight up away from its base
as shown. Power off the monitor and disconnect its main power harness. Collect the
following tools that will be required to perform the CobraMax installation.
2. Remove the spring pins and either the override nuts or handwheels from the Cobra
Assembly. Save these parts in a place where they will not be lost or damaged, they
will be used again later. Use Channellock pliers to attach the CobraMax override shaft
extensions with the provided 1/8" diameter, 5/8" long spring pins. Further secure the
override shaft extensions in place by installing the provided #10-32 set screws into the
override shaft extensions. Apply blue Loctite #243 or an equivalent thread locker to the
screw threads.
Tools Required for Assembly:
• 1/8" Diameter punch
• Hammer
• Channellock Pliers
• 1/8" Allen or T-Handle Wrench
• 9/64" Allen or T-Handle Wrench
• Torque Wrench or Screwdriver w/ #2 Phillips
• 3/8" or Adjustable Wrench
• Loctite #243, or equivalents
• O-Ring Compatible Grease
¾" Nut Override Removal
Handwheel Override
Removal
Attach Override Extensions
and Set Screws
