38
Gateway
Model: 7015X2GW
FCC ID: QT8EXM2GW
FCC Statements:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules . These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment .
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications . Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense .
Modifications made to this equipment not expressly approved by Elkhart Brass Mfg . Co ., Inc ., could void the users authority to operate the
equipment .
FCC and ISED Radio Frequency Exposure WARNING: In order to comply with FCC and ISED RF Exposure requirements, the device should be mounted
in the vehicle such that a minimum separation distance of 20 cm is maintained between the device (and/or its antenna) and any persons during
normal operation . This device has been evaluated only with the provided half-wave Lynx 915 MHz antenna and must never be altered by installers/
end-users . To allow the antenna to be mounted external to the vehicle and the Gateway to be mounted inside the vehicle out of sunlight, in a dry
location with connectors facing down ( to help keep the connectors and seals dry) a provided 2m low loss coax is provided .
HVIN: EXM2GW
IC: 4637A-EXM2GW
Innovation, Science and Economic Development Canada ( ISED ) Statements:
RSS-Gen and RSS-210 statement:
This device complies with Industry Canada license-exempt RSS standard(s), Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device .
Le present appareil est conforme aux CNR d'lndustrie Canada applicables aux appareils radio exempts de licence . L‘exploitation
est autorlsée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouiliage, et (2) l'utilisateur de l’appareil doit accepter tout
brouiliage radioélectrique subi, meme si le brouiliage est susceptible d'en compromettre le fonctionnement .
RSS-102 Statement:
This equipment complies with Industry Canada radiation exposure limits set forth for an uncontrolled environment .
Cet equipement est conforme a l'exposition aux rayonnements industry Canada limites établies pour un environnement non controlé .
RSS-GEN 6 .8 Statement:
This radio transmitter, 4637A-EXM2GW, has been approved by Innovation, Science and Economic Development Canada to operate with the antenna
types listed below, with the maximum permissible gain indicated . Antenna types not included in this list that have a gain greater than the maximum
gain indicated for any type listed are strictly prohibited for use with this device .
This device has been designed to operate with the antennas listed below, and having a maximum gain of 1 .2 dBi . Antennas not included in this list or
having a gain greater than 1 .2 dBi are strictly prohibited for use with this device . The required antenna impedance is 50 ohms .
Approved antenna list:
Model
Number
Type
-------------------------------------- ----------------------------------------------------------------------------------------------------------------
ANT-916-CW-HWR-SMA
half-wave center-fed dipole antenna, SMA Connector
Ce transmetteur radio, 4637A-EXM2GW, a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous avec
le gain maximal admissible et l'impédance d'antenne requise pour chaque type d'antenne indiqué . Types d'antennes ne figurent pas dans cette liste,
ayant un gain supérieur au maximum le gain indiqué pour ce type, sont strictement interdites pour une utilisation avec cet appareil .
Ce dispositif a été conçu en vue de fonctionner avec les antennes énumérées ci-dessous, et ayant un gain maximal de 1,2 dBi . Il est formellement
interdit d’utiliser avec ce dispositif des antennes non comprises dans cette liste ou des antennes ayant un gain supérieur à 1,2 dBi . L’impédance
électrique requise pour l’antenne est de 50 ohms .
Liste d’antennes approuvées:
Numéro de modèle
Le genre
-------------------------------------- -------------------------------------------------------------------------------------------------------------
ANT-916-CW-HWR-SMA
antenne dipôle demi-onde à alimentation centrale, connecteur SMA