MACHINE STATUS MENU
Access the Machine Status menu by pressing
and releasing the key. If no alarms are active, the ‘SEt’ label appears.
Use the keys
and
to scroll through all the folders in the menu:
-
AL
:
alarms folder (
only visible if an alarm is active
);
-
SP1
:
Setpoint 1 setting folder;
-
Pb1
:
probe 1 - Pb1 folder;
Setting the Setpoint:
To display the Setpoint value press the
key when the ‘SEt’ label is displayed.
The Setpoint value appears on the display. To change the Setpoint value, press the
and
keys within 15
seconds. Press
to confirm the modification.
Displaying probes:
When label Pb1 is present, press the
key to view the value measured by the corresponding probe (
NOTE
:
the value cannot be modified).
PROGRAMMING MENU
To access the ‘Programming’ menu, press the
key for more than 5 seconds. If specified, an access PASSWORD
will be requested: ‘PA1’ for User parameters and ‘PA2’ for Installer parameters (see ‘PASSWORD’ paragraph).
User
Parameter: When accessed, the display will show the first parameter (e.g. ‘diF’). Press
and
to scroll through all the parameters on
the current level. Select the desired parameter by pressing
. Press
and
to modify it and
to save the changes.
Installer
Parameter: When accessed, the display will show the first folder (e.g. ‘CP’). Press
and
to scroll through the folders on the
current level. Select the desired folder using
. Press
and
to scroll through the parameters in the current folder and select the
parameter using
. Press
and
to modify it and
to save the changes.
NOTE
: Make sure you switch the instrument off and on again each time the parameter configuration is changed, in order to prevent mal-
functioning in the configuration and/or timing in progress.
