U-00235
5
Center Support Bar
Step 9:
Insert the
Center Support Bar (o)
into the upper top groove on the back of the frame with the bottom end
near the approximate center point of the frame and rotate it in at an angle so that both ends of the bar are in alignment
with the groove.
Diagonal Sizes of 150” and below use 1 x Center Support Bar
Step 10:
Hook one end of the spring and secure inside the groove of the frame, use the
spring hook (h)
to attach
the spring to the hole located on the screen material’s outer edge in the following order.
Begin by first attaching the center points on both vertical (left/right) sides,
steps 1-2
. Then the center points on both
horizontal (top/bottom) sides,
steps 3-4
. Once all center points have been secured, make sure the screen material is
still within the marked areas before proceeding to attach the next springs.
Continue attaching the rest of the springs to the material in the following order in
steps 5-12
.
h.
i.
5
6
7
8
9
11
10
12
Spring must hook
both overlapping
short rods
3
4
1
2
p.
