Elite ProAV Presenter Pro DarkUST 2 Series, User Manual, Page: 9 / 10

Rev.11042021-JA www.eliteproav.com 9
Two Person Setup/Disassembly Instructions
Frame Assembly
2. Take the folding frame (A) out of the
carrying bag (H) and place it on a flat surface.
Unfold the longer sections first.
3. Unfold the frame until the latch on the hinge
"clicks" into place. Repeat the procedure for the shorter sections.
3. Make sure all 4 corners of the frame are at a 90° angle and the hinged support bar
is straight and not bending. After unfolding the frame, make sure to lay it out with
the Velcro facing down.
Leg Attachment
4. Carefully take the folding legs (B) out of the carrying bag (F) and place them on a flat surface.
5. Lay the legs over on the back of the frame in the position desired. Once you have aligned the leg’s holes
with the frame’s holes, secure with the
knob screws (G)
.
6. Then, lift the screen up while simultaneously
opening the front frame legs.
7. Next, carefully unfold the extra support leg behind the leg and attach it securely using a
knob screw (E) .
Unrolling the material
9. Carefully take out the screen material tube from the carrying bag and
ONLY handle it HORIZONTALLY with two hands to avoid dropping
it.
ATTENTION: NEVER handle the screen material tube
VERTICALLY or stand it to avoid crushing the material.
9. Once the screen material tube is on a flat surface horizontally,
remove both end caps and gently pull out the screen material out of
the tube.
10. Unroll the material, remove the protective foam sheet, and set it
aside.
11. Roll the material again to prepare for attaching it to the frame and note where
TOP and BOTTOM
labels are.
Warning: The additional support sections, located at the middle section of the legs, may unfold on its own. Please
be sure to use caution while removing/placing the legs from/to the bag.