Elite Greenhouses 6'3" WIDE CRAFTSMAN, Instructions & Illustrations

Page: 23 / 28

23
FITTING THE KEEP FOR THE LOCK SINGLE DOOR
The cam on the lock must locate onto a door keep which is fitted to the left hand glazing bar (when
viewed from outside) of the door gable end.
The keep has 2 horizontal slots on one face. Insert 2 cropped
head bolts into the bolt channel of the left hand glazing bar and
line up with the slots in the keep.
Close the door to the keep and adjust the height of the keep un-
til the cam on the lock locates in the long oval slot.
The picture shown is viewing the keep from the inside.
FINISHING OFF
To prevent the door from sliding past its opening, you must fix 2 angle brackets to the door end as-
sembly.
Insert a cropped head bolt into the bolt channel at the top of the left hand glazing bar (viewed from
the inside) and fix and angle bracket as shown in the picture below.
The bracket must be fitted at the same height as
the door panel so that, as the door moves left or
right, the bracket prevents the door from moving
too far along the top door track.
Repeat at the bottom of the door.
HARD STANDING
Having established the square of the greenhouse, drill the patio or concrete in the required positions,
fit plastic plugs and screw the angle brackets (attached during subassembly) firmly to the ground
using 35mm x 8mm round head screws.
N.B. If you are on a hard standing the corner brackets (4-1
each corner) need to be trimmed level with the bottom of the built-in-base.
SOIL FLOOR
Determine the square of the greenhouse as described above, make a mix of concrete and put a cou-
ple of shovelfuls around the base of each corner bracket. When the concrete has gone off back fill
with the soil excavated earlier on.