Elite Greenhouses 6'3" WIDE CRAFTSMAN, Instructions & Illustrations

Page: 12 / 28

12
DOOR END ASSEMBLY
COMPONENTS
1 Door end cill
2 Built in base
2 End glazing bars (longer than rear end glazing bars)
2 Rectangular plates with 3 holes/slots
2 Short horizontal angles
2 Roof corner bars (marked ‘R’)
2 Side corner bars (unmarked)
1 Door track support
1 Top door track
1 Small angle door track support
2 Door end diagonal angles
From the main bag of fittings you will require the nuts and bolts.
You will also require 2 eave gusset plates and 1 ridge gusset plate. These are packed with the
casement stay and are separate from the main bag of fittings.
INSTRUCTIONS
Please note, you only require approx. 40mm of beading in the inside ‘v’ groove of the end glazing
bars.
1. Assemble the frame in exactly the same way as the rear end, up to and including stage 3 of the
rear end. The difference with the door end is that instead of 1 long built in base piece, the door
end has 2 smaller pieces (1 either side of the door opening) and 1 door end cill.
2.
Now engage the door end cill with the 2 built in base pieces by pushing the angle of the cill
under the locator as shown in the diagram. At this stage the cill will move freely left and right
but will remain located to the built in base cill.
N.B. The short door end built in base sections have an extra slotted hole at the other end (nearest to
the door opening) which will not be utilised in the assembly, but is there so that the built in base
pieces do not require handing i.e. left can go on right and visa versa.