Tracing Phone Lines
1) Connect the RJ-11 cable with the transmitter and
phone jack.
2) Switch on the transmitter.
3) Push the SCAN button on the transmitter and the
SCAN indicator
will switch on.
4) Activate the receiver by pressing and holding the
SCAN button.
5) Move the receiver close to each phone line. The line
with the
loudest tone is the intended line.
Note: Press Hz button to adjust the tone Frequency
for easily
identify the signal from the environmental noise.
Tracing Data I LAN Cable
1) Connect the RJ-11 / RJ-45 cable with the
transmitter and phone jack.
2) Switch on the transmitter.
3) Push the SCAN button on the transmitter and the
SCAN indicator will
switch on.
4)Activatethe receiver by pressing and holding the
SCAN button.
5) Move the receiver close to each phone line. The line
with the loudest
tone is the intended line.
Note: it is allowed to plug in the testing cable to the
transmitter
directly if the testing cable was installed with plug.
Note: Press Hz button to adjust the tone Frequency
for easily
identify the signal from the environmental noise
