Operating The Equipment
Tracing Pairs
1) Connect the cable with alligator clip to the transmitter.
2) Connect the red clip to one of the tracing wire and the black
clip to the other.
3) Switch on the transmitter.
4) Push the SCAN button on the transmitter and the SCAN
indicator will switch on.
5)Activate the receiver by pressing and holding the SCAN
button.
6)At the opposite end of the wire, move the receiver tip near
each pair. The pair with the loudest tone is the intended
pair.
Tracing Cables
1) Connect the cable with alligator clip to the transmitter.
2) Connect the red clip to:
a) wire in the unknown cable for cables with multiple wires.
b)The outer shield for tracing a shielded / coaxial cable.
3) Connect the black clip to:
a)Anotherwire in the unknown cable but not in the same pair
or to ground for cables with multiple wires.
b)The cent er conductor or ground for tracing a shielded /
coaxial cables.
4) Switch on the transmitter.
5) Push the SCAN button on the transmitter and the SCAN
indicator will switch on.
6) Activate the receiver by pressing and holding the SCAN
button.
7) Move the receiver towards a section of the wall where the
cable could be located. When the loudest tone is obtained,
the cable is located there.
