English
67
Replacing:
• Dismantle the brake calliper by removing the 2 M6 bolts
using the size 10 spanner.
• Remove the lock
• Gently remove the brake blocks on the underside of the
brake calliper.
• Only replace with original Magura brake blocks.
Note:
• Never depress the pistons if brake blocks have not been fitted as this could cause damage.
• When installing new brake blocks, the friction area must face inwards, towards the disc.
• Then replace the lock
• Replace the brake calliper in the usual place
• Then engage the brakes several times (pump them) until the brake blocks set themselves
and a fixed pressure point is reached.
11.4.3.10
Lubricating and tensioning chain
The machine has 1 chain drive, that being the transmission between the hydrostatic engine
and the differential.
Its capacity and RPM are very limited, hence the choice for a single (simplex) chain.
Caution:
Never tighten the chain too tightly. Too much driving capacity would be required
as a result, leading to extra wear of the chain and sprockets. Furthermore, a high
radial tension can harm cap seals and bearings.
For your information:
When checking the chain tension, also check the chain and the sprocket for
extensive wear. If the teeth are worn the sprockets and chain must be replaced.
Visit your authorised ELIET dealer for assistance.
