39
English
11.4. Routine check before each operation
11.4.1. Visual inspection
It is essential before commencing the work that the machine is inspected. This will allow you to
anticipate breakage or wear and tear that affects the life span of the machine.
• Check the condition of the blades. Bent blades should be straightened.
• Check whether the machine operates at the proper rotational speed at full throttle (3,200 RPM)
• Never attempt to change the standard settings for the engine.
• Check that the protective covers are securely fastened.
• Check that the housing is clean.
• Check that no parts are deformed, that welded seams are not cracked and that parts are not
excessively loose.
• If problems are found, carry out the necessary repairs first.
Consult your authorised ELIET service centre for assistance if necessary or to obtain spare parts.
Find an ELIET service centre near you at
www.eliet.eu
.
11.4.2. Checking and topping up the engine's oil level
If the oil level in the engine drops below a certain level, the engine will automatically switch off.
At that point, the machine will have been operating with insufficient lubrication for some time. In
order to avoid this situation, regular checks on the oil level are essential.
• Place the machine on flat ground so that the engine
plate is horizontal.
• Switch off the engine.
• Leave the engine to cool down for about 15 minutes.
• Now remove the filler cap
(1)
from the crankcase.
• The oil should be visible in the opening of the screw plug
up to the edge
(2)
.
• If the oil tank is not filled to the brim, this indicates a lack
of oil.
• If the oil level is too low
(3)
, top it up via the filler
opening. Continue to add oil until the desired level is
reached.
• Always use recommended oil (see the list of recommen-
ded oils in the engine manual).
• Since the location of the filler opening is tricky to reach,
we recommend using a tube or special funnel to avoid
oil spills. Always clean the funnel before passing any oil
through it.
1
2
3
