EL2700 IP-Based Access Control System
User Manual
Revision 2.0
30
PIN Dis TZ
Door 1
PIN Dis TZ [D1]
SUN: 00
DS Debounce
D1:OFF
D2:OFF
DS Debounce
D3:OFF
D4:OFF
The user
must press the “
” key until the display shows “Enter Pin”,
indicating that the controller is ready to read PIN number. The
display will show
a “
” symbol for each digit keyed in. When the
correct number is keyed in, the door lock will be activated, and the
display will show
“Valid entry”. If the number entered is incorrect,
the display will show
“Invalid PIN” and the door will remain closed.
3.7.11 Door Sensor Debounce
The controller will sense the door open after 2s while the door open with a
valid card. You can change the time to any other values 0.5, 1. 2, 5
and 10 seconds. For example, set the debounce time to 1 second so
within 1 second if the door close no need to batch again.
3.7.12 PIN Disable Time Zone
This command is for setting the time zones during which
Card+PIN mode is automatically deactivated. When this
command is executed, the following screen appears:-
You can select either to add PIN only list in Door 1, Door 2, Door 3
or Door 4. Press
“
B
” or “
C
” Key until the desired door is displayed,
then press <
#
>. There after, the following screen will appear:-
