ELICA GETUP BLGL/A/90, Instruction On Mounting And Use Manual

Page: 35 / 204

14
Reset filter saturation indicator:
Press and hold button T3
LED L1 (a-b-c) turns on and off (depending on the type of
filter being reset, the indicator lights flash together or turn on
in sequence); an acoustic signal will confirm the reset
operation.
Activation of filter saturation indicator
Note:
this operation must be performed with the hood off.
- Grease filter
This indicator is normally activated
1st prolonged press of buttons
T3 and T2
if the indicator is active, button
T3 turns on
press button T2 , to deactivate it
if the indicator is not active, button T2 turns on
press button T3 , to activate it
- Active carbon filter
This indicator is normally deactivated
2nd prolonged press of buttons
T3 and T2
if the indicator is active, button
T3 turns on
press button T2 , to deactivate it
if the indicator is not active, button T2 turns on
press button T3 , to activate it
Note: 3rd prolonged press of buttons T3 and T2
to exit settings menu.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent. DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS . Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
When inserting and removing grease filters and charcoal
filters, please make sure that the extractable unit of the hood
is in open position.
Then remove the front panel ,by pulling on the upper part of
each side at the same time.
The panel turns forward ,so that grease filters can be inserted.
Fig. 18-21
Charcoal filter (filter version only)
It absorbs unpleasant odors caused by cooking.
Washable activated charcoal filter
The charcoal filter can be washed once every two months (or
when the filter saturation indication system – if envisaged on
the model in possession – indicates this necessity) using hot
water and a suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
After removing the grease filter, it is possible to insert the
charcoal filters (
not supplied ).
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
To replace lights, contact authorised spare part center.