ELGO Electronic Z58-600 Series, Operating Manual

Page: 13 / 28

Pin Assignments
- 13 -
7.2 Connection of Z58-654 (VAC Versions)
Additional description for connecting devices with 115 or 230 VAC power supply
ATTENTION!
The following functions, encoders and options (

14) are not available with VAC-versions (654):
1. Unavailable Standard Functions:
For technical reasons, no relay outputs can be equipped.
2. Unavailable Measuring Systems:
1 = A/B/Z with 24 VDC encoder supply, HTL (PNP), 100 KHz
2 = A/A’ B/B’ Z/Z’ with 24 VDC encoder supply, TTL (PNP), 100 KHz
3 = A/A’ B/B’ Z/Z’ with 5 VDC encoder supply, TTL (PNP), 100 KHz
4 = compatible to ELGO FMAX absolute encoders
5 = compatible to ELGO EMAX absolute encoders
8 = A/A’ B/B’ Z/Z’ with 24 VDC encoder supply, TTL (PNP), 500 KHz
9 = A/A’ B/B’ Z/Z’ with 5 VDC encoder supply, TTL (PNP), 500 KHz
3. Unavailable Options:
F = analog output 0 ... 10 V
G = analog output 0 ... 20 mA
H = analog output 4 ... 20 mA
REMARK!
The 115/230 VAC versions are mainly offered to replace the predecessor type Z54 standard.
For technical reasons the above encoders and options cannot be realized here. However, if you
need any of the above encoders/options and do not have a 24 VDC power supply, please use
the Z58-600 standard device in combination with the external ELGO power pack NG24.0,
which is available as an accessorial component (

14.1).
7.2.1 Pin Assignment of Z58-654
Table 3: Pin Assignment of Z58-654
Rear Pin ST2 - (external inputs)
1 Screen / shield
2 0 V / GND
3 +24 VDC out (HIGH level)
4 Tool-offset (active high)
5 Reference (active high)
6 Reset (active high)
Pin ST1 - (rotary encoder) Pin ST3 - (AC supply)*
1 0 V / GND (encoder supply) 1 L1
2 +24 V out (encoder supply) 2 N
3 Channel A 3 PE
4 Channel B
*) ST3 is not required for option AG (built-on housing).
A separate connector for AC supply is included.
5 Screen / shield
ST1
1 2 3 4 5
ST2
1 2 3 4 5 6
External power plug
only with option AG*
ST3*
1 2 3