ELGO Electronic Z58-600 Series, Operating Manual

Page: 18 / 28

Design and Functions
- 18 -
9.4 Parameter List
Table 4: Parameter list
Parameter Function Range Default Setting
P 00 reserved for test purposes - - - - - -
P 01 Counting direction (0 = up / 1 = down) 0, 1 0
P 02 no function / reserved - - - - - -
P 03 Decimal place 0, 1, 2, 3 1
P 04
Actual value memory
(0 = enabled / 1 = disabled)
0, 1 0
P 05 Front keys (0 = enabled / 1 = disabled) 0, 1 0000
P 06 Edge evaluation (0 = x 1, 1 = x 2, 2 = x 4) 0, 1, 2 0
P 07
Measuring system selection:
(0 = A/B Encoder, 1 = RS422 Encoder,
2 = EMAX/FEMAX, 3 = FMAX,)
0, 1, 2, 3
0
P 08 Multiplication factor 00.0001 ... 99.9999 01.0000
P 09 Reference value −99999.9 ... +99999.9 00000.0
P 10 Tool-offset −99999.9 ... +99999.9 00000.0
P 11 Saw blade thickness 0 ... +99999.9 00000.0
P 12 Preset limit relay 1 (min) −99999.9 ... +99999.9 00000.0
P 13 Preset limit relay 2 (max) −99999.9 ... +99999.9 00000.0
P 14 Display brightness 0 ... 9 5
P 15 no function / reserved - - - - - -
P 16 Load default parameters (0 = no / 1 = yes) 0, 1 0
P 17 Measurements unit (0 = mm / 1 = inch) 0, 1 0
P 18 no function / reserved
- - - - - -
P 19 no function / reserved - - - - - -
P 20 Analog output (minimum value) −99999.9 ... +99999.9 00000.0
P 21 Analog output (maximum value) −99999.9 ... +99999.9 00000.0
P 22 ... 98 no function / reserved - - - - - -
P99 Software-Version XX.XX
9.5 Load Default Parameters
Parameter P16 can be used to reset all parameters to their default settings. For this purpose set P16 to „1“,
press
F + Incr/Abs for 3 s at the same time and switch the power of the Z58 indicator 1 x OFF and ON again.