Elgin Pelican P, Operator'S Manual, Page: 71 / 112

9. Remove and save the outer element, taking
care to keep the element clean and to avoid
any damage to the element.
NOTICE
A damaged outer element, or one with a loose, dam-
aged, or missing seal, will allow dust to clog the
inner element.
10. Remove and discard the inner element.
11. Install a new inner element and the saved
outer element, making sure they are correctly
seated.
NOTICE
To prevent damage, the elements must be completely
seated before the canister cover is installed.
12. Securely fasten the cover on the filter canister
with the unloader at the bottom. Make sure all
clamps are correctly fastened.
13. Check the whole air intake system for leaks.
FUEL SYSTEM
The fuel lift pump (C, Figure SP-3) draws fuel from
the fuel tank (K) and pushes it through the fuel fil-
ters (G) to the injection pump (A). The injection
pump forces fuel through the injectors (E), which
atomize the fuel and spray it into the combustion
chamber of each cylinder. The low pressure leak-
off return line (H) from the injection pump passes
through each injector and returns to the fuel tank.
DRAINING FUEL WATER
SEPARATOR
The water separator on the bottom of the fuel filter
(Figure SP-4) should be checked daily and drained
when needed. Frequency of draining will be deter-
mined by operating conditions and quality of the
fuel.
To drain the separator, use the following procedure.
SP-5
SER
VICE
PROCEDURES