miniELCOR
73
14.2 Device connection with PC
The device can be connected with PC either with help of cable by force of serial
interface RS-232 (eventually RS-485), infrared-head (HIE-01) or eventually via
modem.
For device setting in terrain is best to use infrared-head or cable RS-232 (see
Fig. 18). In case of communication through infrared-head is to this communication
assigns the highest priority and the device will automatically choose this
communication.
Warning:
If is the PC used in the explosive surround (ZONE 1 or ZONE 2), then must be
during connection between device and PC accomplished all protecting norms.
Communication parameters (default setup)
In the device are pre-set from the manufacture these parameters for connection with
PC (or modem):
Communication speed, interface RS232/RS485
38 400 Bd
Communication speed, optical interface of infra red head
9 600 Bd
Communication protocol
ELGAS (ver. 2)
Communication address of device (see further)
Address1=0
Address2=0
14.3 Setting of communication between device and PC
When is device connected with PC, then it is possible to start-up service SW
with double-click on its „exe file“. After SW starting are displayed already defined
devices (consumption places) see Fig. 31. In this list is for one device determines
one line. In each line are defined all parameter for device identification and for
communication line assignment. User may edit parameters very easily with double-
click on each window. By some parameters symbol of arrow is displayed in right
corner. Clicking on this arrow user can choose from several possibilities. When user
cannot find the device in the list or the list is empty so it is necessary to make a new
line with definition of new device (consumption place). The new line is made out after
click on icon „+“. Parameter setting of new consumption place is the same like editing
of existing consumption place.
14.3.1 Parameters setting of consumption place
By all consumption places are in columns arrange identifying data and data
which are necessary for communication.
Station description –
users marking of station
Station identification
– station marking; this marking (name of the
consumption place) must be the same with marking, which will be written in
the device memory
Summary of Contents for miniELCOR
