Elgas miniELCOR, Operation Manual, Page: 117 / 131

miniELCOR
110
17.1.2 Newly installed digital transducer has different address from
address preset in device’s parameters
If we will found that transducer is not communicating, probably has a different
communication address than is preset in device’s parameters. To set correct address
click in device’s parameters on transducer item (in our case „
Temperature EDT-34 “
see Fig. 70). After that in right part of the window click on „ New address “ button.
Service software will ask you to enter serial number of added transducer. Enter serial
number and click „
OK “ (see Fig. 73). After that service software will ask you to enter
new communication address. Enter the same address which is stored in device’s
parameters – standartly it is the address no.1 (see Fig. 74). New address is stored in
transducer now.
By clicking on „ Parameters of module “ button we will check if transducer is
communicating properly with the device. If everything is correct you will see window
with transducer’s parameter (see Fig. 71). Herewith we finished the change of
address and also installation of transducer is finished.
Note: After adding of digital transducer it is possible (if needed) to make one or
two point calibration of transducer. (see Fig. 72).
17.2 Adding of quantity measured by digital transducer
into device’s archives
After addition of digital transducer into device’s parameters it is also necessary
to add quantity (temperature in our case) measured by this transducer into archives.
If we will not add this quantity as a new item into archives this information will be
shown only in actual values.
In device’s parameters click on quantity which is measured by digital
transducer (see Fig. 76). In right part of the window tick-on archives where you want
to have stored this quantity. In the end save this change into device by clicking on
„
Save into device “ button.