Manual operating of flash lamps FX PRO serie
www.elfo.com.pl
Page 7
7.
Bulb mode switch
Modelling light bulb operation mode is controlled. There are three modes available.
Repeatedly pressing changes operation modes. The round border of button shows present
status of the lamp:
Shines steadily – modelling light always shines.
Blinks – light shines only when lamp is ready to flash.
Light off – modelling light doesn’t shine.
Level of modelling light energy is relative to settings of modelling light mode switch (3).
8.
External control panel socket
Jack RJ-45 connector for connecting an external control panel. Control panel takes over
control of all functions (except USER settings). When control panel is connected, blue border
of TEST button is pulsating. Neither buttons on front of the lamp (except TEST button) nor
encoder work. When control panel changes the value, borders of corresponding buttons
response. The latest values of lamps are restored when control panel is disconnected. There
is one type of panel that automatically detects up to which lamp is plugged and takes over its
control range.
There are almost no differences between maintenance of lamp by means of control
panel and of main front panel of the lamp. There are the same symbols that make the
maintenance easy. Each press of button causes mode and signalling change. Energy control
element consists of two buttons „-„ and „+”, instead of revolving potentiometer, for utilitarian
conditions. Each press (7) or (2) button makes energy increased or reduced by 1/10 f-stop.
Control panel is equipped with cable 10 m long.
External control panel is not standard equipment. It can be bought separately