Elesa CE.99951, Operating Instruction

Page: 9 / 24

9
EN
MPI-R10 Magnetic measuring system Magnetic measuring system
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
6. Key function
Key
Operating
mode
Programming
mode
SET Keep pressed for 3 sec to enter the programming
mode
Parameter selection /
Confirm of parameter
change
ORG
Programmable with one of the following options (see
the
_ _ _ _ 0 _ _
voice of the menu cap. 8.3):
d_tArG
: when a target is loaded the display shows
the actual absolute position. Pressing the key, on the
display appears the target absolute position to reach.
d_to_GO
[DEFAULT]: when a target is loaded
the display shows the distance to reach the target
position. Pressing the key, on the display will appear
the actual absolute position.
OFF : the key is not assigned to any function in the
operating mode.
Digit increase /
Scroll for parameters
bottom-top on the
menu tree
ABS-REL
Select the:
ABS
: absolute measuring mode.
REL
: incremental measuring mode.
It is possible to choose one of the following options
(see the
_ _ 0 _ _ _ _ voice of the menu – cap. 8.3):
ArCLr [DEFAULT]: switching from ABS to REL
the counter is set to zero.
Ar
: switching from
ABS
to
REL
the counter is not
set to zero.
OFF
: the key is not assigned to any function in the
operating mode.
Digit decrease /
Scroll for parameters
top-bottom on the
menu tree
mm-inch
Press the key to select the unit of measure needed.
The options available are: millimeters, inches and
degrees.
It is possible to choose one of the following options
(see the
0 _ _ _ _ _ _
voice of the menu – cap. 8.3):
ALL
[DEFAULT]: selectable units of measure: mm,
inch, D.
nodEG : selectable units of measure: mm, inch.
OFF : the key does not allow the unit of measure
conversion.
Programming mode
exit /
Digit selection