12
EN
MPI-R10
Magnetic measuring system
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
7.3 Setting the absolute reference
The system allows you to store up to 10 values of compensation offsets (see
OFFSEt
in cap. 8.2).
This allows you to adjust the value shown on the display in such a way that takes
into account, for example, wear or tool change.
It is possible to set the value of the actual position of the indicator to a value equal
to the sum of the parameter
OriGin
and one of the
OFFSEt
.
After selected the absolute measuring mode and stopped the sensor in the
starting or reference position:
- press the key combination
ABS-REL
+
SET
;
- choose the wanted compensation offset pressing the key
ABS-REL
;
- confirm the selection pressing the key
SET
.
WARNING
To access thi function verify the seting at the menu voice
__0___0
(see
cap.8.3).
The available options are:
-
LOAdOrG
: the key combination allow to choose an offset compensation;
-
OFF
: the keys combination is disabled.
7.4 Direct programming of the absolute reference value and compensation
values
The keys combination
mm-inch
+
SET
can be programmed to allow direct access to
setting of the
OrIGIn
or
OFFSEt
parameters.
To do this, select one of the available options at the voice of the menu
0 _ _ _ _ _ 0
(see cap.8.3).
The available options are:
-
PrOGOrG
: direct programming of the absolute reference value (
OrIGIn
parameter).
-
PrOGOFS
: direct programming of the compensation value (
OFFSEt
parameter).
-
OFF
: the keys combination is not associated to any function in the operating
mode.
Summary of Contents for CE.99951
Page 1: ...Electronic Magnetic Meter OPERATING INSTRUCTION MPI R10 ...
Page 23: ......
