elero MemoTec-868, Operating Instructions Manual

Page: 9 / 10

GB-16
Programming weekly control commands/
Technical data/Battery replacement Cleaning/Troubleshooting/
General declaration of conformity
GB-15
GB
Operating voltage 230-240 V AC / 50-60 Hz
Battery requirements 2 x LP03 (AAA)
System of protection IP 20
Permissible ambient temperature 0 to +55 °C
Type of installation Wall installation
Operating frequency 868,3 MHz
The maximum radio operating range is 25 m indoors and 350 m
outdoors.
Technical data
Cleaning
Clean the device with a damp cloth only.
Do not use a cleansing agent as doing so may damage the plastic.
Troubleshooting
Problem Cause Remedy
Drive is not Faulty connection. Check connection.
functioning.
Drive moves in the Faulty connection. Exchange V and B
wrong direction. wires in the power
supply unit.
MemoTec-868 does Sliding switch is set to Set the sliding switch
not execute the manual mode. to automatic mode.
programmed control
commands.
Switching times are not Programme switching
programmed.
times.
General declaration of conformity:
The company elero GmbH hereby declares that the MemoTec-868
device complies with the basic requirements and other relevant
regulations of the EC Directive 1999/5/EG.
Deleting weekly control commands
1. To delete all weekly control commands, press the week
programming button for 5 seconds or longer.
The control light will flash 3 times briefly to confirm.
Note: If weekly control commands are deleted, your shutter/blind
will be operated on the basis of the stored daily control
commands
Battery replacement
1. Open the battery compartment.
2. Insert the new batteries
properly .
LR03 (AAA)
LR03 (AAA)
--
--
Note: Batteries must be replaced
within one minute .
Ensure that none of the
buttons on the device are
pressed
in the process .