elero MemoTec-868, Operating Instructions Manual

Page: 4 / 10

Explanation of functions
GB-6
GB
Installation
GB-5
Wall holder installation
• Before installing the wall holder, always ensure that the
transmitter and receiver are in proper working order.
• Mount the holder onto the wall using the two screws provided.
Note: Radio base stations transmitting in the same frequency
range may cause reception interference.
Please note that the operating range of the radio signal is
limited by legislation as well as by the product design.
Explanation of functions
Manual/Automatic sliding switch
When the sliding switch is set to MANUAL , only manual control
commands are executed.
When the sliding switch is set to
AUTO , manual and automatic
control commands are executed (time).
Control light
The control light flashes 3 times to confirm switching time settings.
RESET button:
Pess the Reset button (with a ballpoint pen or similar object) to
delete all control command settings, the intermediate position
and the ventilation/reverse position.
Intermediate position:
The intermediate position lies between the upper and lower limits
of the roller shutter/venetian blind and can be freely selected. The
roller shutter/venetian blind can be moved into this position from
the upper end limit after programming.
To adjust the shutter/blind into the intermediate position, press
the
DOWN button twice in quick succession.
In venetian blind mode, the blind slats are turned automatically
when the intermediate position has been reached, provided a
reverse position has been pre-programmed.
Ventilation/reverse position:
The ventilation/reverse position lies between the upper and lower
limits of your roller shutter/venetian blind and can be freely
selected. Your roller shutter can be moved into this position from
the lower end limit until the ventilation slits are open. In venetian
blind mode, the blind slats are turned.
To adjust the shutter/blind into the ventilation/reverse position,
press the
UP button twice in quick succession.