elero Combio-868 JA Pulse/-915, Operating Instructions Manual, Page: 6 / 9

10 | EN
Warnhinweise
Connection and installation
EN | 11
The Combio-868 RM /-915 for elero tubular motors with plug-
in cable (limit switch drive)
1. Switch off the mains voltage.
2. Press the locking mechanism of the drive plug towards the
cable with a screwdriver.
3. Pull out the plug.
4. Plug the motor cable of the radio receiver into the drive.
5. Connect the mains cable of the Combio-868 RM /-915 correctly
with the mains voltage.
RM /-915
Combio-868
PE
L
N
Antenna
1~
M
Mains
230 V/50 Hz
6. Fasten the radio receiver.
7. Switch the mains voltage on again.
8. Programme the transmitter (→ refer to the transmitter
instructions).
9. Mount the hangings and set the limit switch.
Pin Wire colour
designation 230 V
L
Brown
N Blue
PE Green/yellow
Connection and installation
Combio-868 RM /-915 for tubular motors with plug-in cable
(ACS-E electronic drive)
1. Switch off the mains voltage.
2. Press the locking mechanism of the drive plug towards the
cable with a screwdriver.
3. Pull out the plug.
4. Plug the motor cable of the radio receiver into the drive.
5. Connect the mains cable of the Combio-868 RM /-915 correctly
with the mains voltage.
RM /-915
Combio-868
PE
L
N
combio868rm
Antenna
1~
M
Mains
230 V/50 Hz
6. Fasten the radio receiver.
7. Switch the mains voltage on again.
8. Programme the transmitter (→ refer to the transmitter
instructions).
Note:
Rotate the winding shaft manually in the corresponding
direction.
9. Mount the hangings and operate the drive in the self-program-
ming mode.
Pin Wire colour
designation 230 V
L
Brown
N Blue
PE Green/yellow
Note: Do not shorten or lengthen
the antenna.