11/
18
PRE-USE INSTRUCTIONS
Prior to each gas fire table operation, check the hose and
valve for evidence of excessive abrasion or wear
through the visual check hole on the side of the base.
Replace visual check cap prior to operating fire table.
Burner Connections
Make sure the Natural Gas hose and quick disconnect
socket connections are securely fastened to the burner
and the gas supply. If your unit was assembled for you,
visually check the connection between the burner pipe
and orifice. Make sure the burner pipe fits over the orifice.
Please refer to diagram for proper installation.
If the burner pipe does not rest flush to the orifice, please
contact Elementi at 1-900-985-5553 for assistance.
Checking for Leaks
Make a leak check solution by mixing 1-part dishwashing soap with 3
parts water in a spray bottle.
Make sure control knob is “OFF.” Then, turn natural gas on at its
source.
Spray leak solution on valve connections paying particular attention to
the areas indicated by arrows.
If any bubbles appear turn natural gas off, reconnect and
re-test. If you continue to see bubbles after several attempts,
disconnect natural gas source and contact Elementi at 1-909-985-
5553 for assistance.
If no bubbles appear after one-minute turn source
OFF, wipe away solution and proceed.
6
WARNING
Before using this outdoor fire table, make sure
you have read, understand and are
following all information provided in the Important Safety Information section of this
manual. Failure to follow those instructions can cause death, serious injury or property
damage.
WARNING
Failure to inspect this connection or follow these instructions could cause a fire
or an explosion, which can cause death, serious bodily injury, or damage to
property.
Check for leaks at these locations
