INSTALLATION GUIDE
|
DIM-TO-WARM LED TAPE LIGHT
|
IG090519-1.0
|
5 OF 5
Lucetta Lighting is a division of Elemental LED Inc.
885 Trademark Drive, Suite 200 | Reno, NV 89521 | (833) 533-7732| [email protected]
© 2019 Elemental LED Inc. All rights reserved. Specifications are subject to change without notice.
INSTALLATION GUIDE
CELESTE DIM-TO-WARM LINEAR LIGHTING
SYSTEM DIAGRAMS
The following diagram is provided as an example system design. For information regarding larger systems or systems not
pictured below, please see our web page or contact technical support. Always review each component installation guide for
detailed and up-to-date wiring instructions. Install in accordance with national and local electrical codes.
Magnetic Dimmable Driver System*
1. Driver may not require a fault ground connection. Refer to driver specifications for additional information.
2. Install a compatible Class 2 driver. Refer to each driver specification sheet for full power ratings & load deratings.
8. See fixture specifications for maximum series run limits.
AC Power
50/60Hz
120VAC or 277VAC
Magnetic Low Voltage Dimmer1
V+ (Red)
V- (Blue)
LED Tape Light / Fixture8
L
N
N (White)
L (Black)
Magnetic
Dimmable Driver2
Install applicable wir
e gauge / type
V+
V-
V+
V-
GND (Green)
Some dimmers may require an
additional neutral wire connection.
*If a different Driver from one of our partners is required, please
contact us at www.LucettaLighting.com.
