INSTALLATION GUIDE
|
DIM-TO-WARM LED TAPE LIGHT
|
IG090519-1.0
|
2 OF 5
INSTALLATION GUIDE
CELESTE DIM-TO-WARM LINEAR LIGHTING
Prior to installation, verify all components (LED Tape, Driver, Control, &
Accessories) are compatible. Configure and pre-test your LED system prior to
installation to ensure all components are operating correctly.
SHOCK HAZARD!
May result in serious injury
or death.
Turn power OFF at circuit breaker prior to
installation.
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
1) Class 2
Magnetic Driver
2) Control
3) Tape Light
Refer to
SYSTEM DIAGRAMS.
WIRE GAUGE & VOLTAGE DROP
Ensure applicable wire is installed between driver, fixture,
and any controls in between. When choosing wire, factor in
voltage drop, amperage rating, and type (in-wall rated, wet
location rated, etc.)
CUT TAPE LIGHT TO DESIRED LENGTH
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
+ 24V
-
+
-
Cut at line indicated with scissors icon.
PREPARE CONNECTOR
Using Phillips Head Screwdriver, fasten connector to Strip
Light.
-
+
24V
-
+
-
+
-
+
24V
-
+
-
+
INSERT TAPE LIGHT INTO CONNECTOR
UNSCREW TERMINAL BLOCK CONNECTOR
TERMINAL CONNECTOR
SECURE STRIP LIGHT
Never cut tape attached to a live circuit. Do not exceed Class 2
Limit when loading CELESTE
™
Connectors.
Firmly insert with 3M
™
Adhesive backing still intact to
Tape Light.
INSTALLATION
1
TURN POWER OFF AT CIRCUIT BREAKER
2
DETERMINE LOCATION TO INSTALL
COMPONENTS
3
4
5
6
