33
servicing instructions
The following outlines only the minimum work that
should be performed on an annual basis. This
service work, like any other work on the appliance,
must only be done by a qualified and competent
engineer who is Safe Gas registered.
Open the door and remove all ceramics.
Remove Grate from the firebox.
Remove any debris from the top of the burner
using a vacuum cleaner and brush.
Inspect the burner unit.
Perform an ignition check.
Perform a flame failure check
There should be no need to service the burner. If
however this is required, then the engineer should
check the setting pressure at inlet to burner;
the correct pressure is shown at the rear of the
manual.
Brush off and replace ceramic arrangement as
earlier in this manual, replacing any broken or
damaged pieces.
Check all seal on door (including glass) and re-
place the Door.
Check the installation for gas leaks.
Check flue for clearance of products of combus-
tion.
If any parts need to be replaced use only genu-
ine manufacturer parts, non-standard parts will
invalidate the guarantee and may be dangerous.
Troubleshooting
On the next pages you will find remedies for
problems which may accur when using fires
with full electronic ignition RCE GV60
Figures troubleshooting
Figure 1
Figure 2
SERVICING INFORMATION
34
onderhoudsinstructies
Hieronder volgt een overzicht van het minimale
onderhoud dat jaarlijks moet plaatsvinden. Net
als alle overige werkzaamheden aan het toestel
mag dit onderhoud uitsluitend door een bek-
wame installateur worden uitgevoerd.
Wij adviseren u om daartoe een onderhouds-
contract bij een erkende installateur af te sluiten.
Verwijder de glasplaat en verwijder alle kera-
mische onderdelen.
Verwijder mogelijke puin boven op de brander
met behulp van een stofzuiger en borstel.
Inspecteer de brander.
Voer een ontstekingscontrole uit.
Voer een vlamstoringscontrole uit
Onderhoud aan de brander zou niet nodig
moeten zijn. Is dit wel het geval, controleer dan
de ingestelde druk bij de inlaat naar de brander.
De juiste druk staat achter in deze handleiding
vermeld.
Borstel de keramische onderdelen af en vervang
eventuele gebroken of beschadigde onderdelen
(zie eerder in deze handleiding).
Controleer het keramische koord op de glasplaat
en plaats de glasplaat terug.
Controleer de installatie op gaslekken.
Controleer de afvoer van de rookgassen via het
rookkanaal.
Indien er onderdelen moeten worden vervangen,
gebruik dan alleen originele onderdelen van de
fabrikant. Bij het gebruik van niet-standaard
onderdelen vervalt de garantie. Bovendien kun-
nen ze gevaar opleveren.
Reinigen van glas:
Afhankelijk van de gebruiksintensiteit kan zich
in de loop der tijd een aanslag vormen op het
glas. Deze aanslag kunt u verwijderen met een
ONDERHOUDSINFORMATIE
speciale glasreiniger of een speciale reiniger
voor keramische kookplaten.
Afbeeldingen bij probleemoplossing
Afbeelding 1
Afbeelding 2
A
34
onderhoudsinstructies
Hieronder volgt een overzicht van het minimale
onderhoud dat jaarlijks moet plaatsvinden. Net
als alle overige werkzaamheden aan het toestel
mag dit onderhoud uitsluitend door een bek-
wame installateur worden uitgevoerd.
Wij adviseren u om daartoe een onderhouds-
contract bij een erkende installateur af te sluiten.
Verwijder de glasplaat en verwijder alle kera-
mische onderdelen.
Verwijder mogelijke puin boven op de brander
met behulp van een stofzuiger en borstel.
Inspecteer de brander.
Voer een ontstekingscontrole uit.
Voer een vlamstoringscontrole uit
Onderhoud aan de brander zou niet nodig
moeten zijn. Is dit wel het geval, controleer dan
de ingestelde druk bij de inlaat naar de brander.
De juiste druk staat achter in deze handleiding
vermeld.
Borstel de keramische onderdelen af en vervang
eventuele gebroken of beschadigde onderdelen
(zie eerder in deze handleiding).
Controleer het keramische koord op de glasplaat
en plaats de glasplaat terug.
Controleer de installatie op gaslekken.
Controleer de afvoer van de rookgassen via het
rookkanaal.
Indien er onderdelen moeten worden vervangen,
gebruik dan alleen originele onderdelen van de
fabrikant. Bij het gebruik van niet-standaard
onderdelen vervalt de garantie. Bovendien kun-
nen ze gevaar opleveren.
Reinigen van glas:
Afhankelijk van de gebruiksintensiteit kan zich
in de loop der tijd een aanslag vormen op het
glas. Deze aanslag kunt u verwijderen met een
ONDERHOUDSINFORMATIE
speciale glasreiniger of een speciale reiniger
voor keramische kookplaten.
Afbeeldingen bij probleemoplossing
Afbeelding 1
Afbeelding 2
A
Summary of Contents for vesuvius 100
