1 8
Chapter 10
I N S T A L L A T I O N M A N U A L |
Position the decoration logs as shown on the image below.
Make sure that the pilot flame area and the second thermocouple are
always free of any decorative material to make certain that the fire will
ignite without problems.
Not doing so may cause the fire to explode on
ignition!
10�1�1
CLEANING THE CERAMICS
Gently remove and clean the ceramics in the open air, using a soft brush
and a vacuum cleaner. Where necessary replace damaged components
only with genuine Element4 specified parts. Seal any scrap ceramics in
plastic bags and dispose at proper refuse sites. When using a vacuum
cleaner, it is recommended that one with a HEPA filtering system is used.
Re-fit the firebed arrangement, reseal the appliance and check the safe
operation of the appliance.
10
DECORATIVE (CERAMIC) PARTS
This appliance is equipped with a ceramic fire bed with heat-resistant
ceramic fibers, or artificial glassy silicate fibers. Excessive exposure to
this material may cause irritation to the eyes, skin and respiratory tract.
We therefore recommend that the dust emission is reduced as much as
possible when handling these materials.
10�1
DECORATION ARRANGEMENT
Only the decoration ceramics supplied with this appliance are to be
used. The ceramics must be laid only as shown on this page. Replacement
parts are available from your dealer, but should only be installed by a
qualified installation engineer.
An elaborate decoration instruction is found on the sheet in the logset
that comes with the fire. These instructions show you how to decorate
the fire step by step.
1
4
2
3
7
5
6
Figure 10.1 |
Logset Summum 100
