1 7
Chapter 10
I N S T A L L A T I O N M A N U A L |
10�2
DECORATION INSTRUCTIONS
Step 1:
See
Figure 10.2
The picture on the right shows the empty burner grate. Indicated are the
pilot flame and the second thermocouple. Make sure that these parts
remain free of decoration material at all times for the proper functioning
of the fireplace.
Step 2:
See
Figure 10.3
Place the lava stones on the flat burner so that they break the flames.
Again, make sure that the openings at the pilot and within the bracket of
the second thermocouple cap remain free.
Place a good layer of chips around the burner grid and place the
indicated logs in the correct place on the grid.
For the rest of the logs it is important that the grate is not too full. If
necessary, adjust the position of the decoration material if necessary.
Figure 10.2 |
Safety mechanics
Figure 10.3 |
Lavastones and chips
Figure 10.4 |
Log burners
Figure 10.5 |
Logs
Step 3:
See
Figure 10.4
Place the log burners in the designated openings in the grate.
Step 4:
See
Figure 10.5
Place the rest of the logs in the indicated places. Make sure the logs
are placed over the burners such that they are completely covered.
Logs 1 and 4 should be placed in such a way that they hang above
the flat burner, but do not lie directly on the burner or lava stones.
The flames must pass between the blocks for the fireplace to function
properly.