Element4 E4-10, Installation Manual

Page: 26 / 49

2 5
Chapter 9 I N S T A L L A T I O N M A N U A L |
9�1�5 MOUNTING AND DISMANTLING COVER STRIPS SUMMUM 140 4S
Decorative trims are available for finishing the fireplace (See
Figure 9.14
.)
. When replacing or temporarily removing the lists, the following order of
removal must be observed;
Disassembly
• The Summum 140 4s has two decorative frames around the glass.
These are held by magnetic snappers, (
Figure 9.15
) and can easily
be pushed off the casing.
Assembly
• Reinstall the covers in the reverse order of which they were
removed.
9�1�6 REMOVE GLASS FROM THE SUMMUM 140 4S
Pay attention ! When the chimney breast is fully and correctly installed,
it must be possible to remove all the glassware from the fireplace
without it sinking or, on the other hand, ensuring that the glass cannot
be put back again.
To be able to clean the glass on the inside, the glass must first be
removed. For this you can follow the following steps:
• First remove the decorative frames, as discussed in 10.1.5 .
• Remove the glass clips by loosening the screws. (See
Figure 9.16
)
• Place the suction cups on the glass and ensure that it is properly
sucked in so that the window cannot come loose (
Figure 9.17
).
• Lift the window a little and tilt it out of the fireplace through the
opening. (
Figure 9.18
)
• Repeat these steps as shown in
Figure 9.19
to
Figure 9.20
for the
panes on the ends of the stove.
For the partition glass it applies that it is attached to the top of the
fireplace with a glass clamp (
Figure 9.24
). Unscrew it and remove the
glass if necessary with the help of the suction cup (
Figure 9.25
to
Figure
9.27
).
Figure 9.14 |
Isometric view of Summum 140 4S