61
MAINTENANCE
Element4 Gas Fireplaces
European
Home
.com
REMOVING AND CLEANING THE GLASS
Step 1.
Remove all of the trim pieces from the fireplace. The location and
quantity of trim varies with model but in every case there is no top
trim. The trim pieces are held firmly in place with magnets and will
simply lift out. The bottom (horizontal) trim pieces are at the lower
edge of the glass panels and the side (vertical pieces) are where the
glass meets the wall.
Step 2.
Gasketed glass clamps hold the edges of the glass panel in place.
The quantity and location of the clamps vary by model. Remove the
retaining bolt(s) holding the glass clamp and then remove the clamp.
Remove all of the retaining bolts and clamps holding in the first
piece of glass.
REMOVING THE GLASS
• No. 2 Phillips screwdriver (not included)
• Vacuum clamp (included with ‘140’ model fireplaces only)
TOOLS REQUIRED
The glass panels on this fireplace are held in place by a number of
retaining bolts and gasketed clamps. These instructions will show
you how to remove and install the clamps and glass panels.
Please read these instructions completely before proceeding.
OVERVIEW
Except for tunnel and single-sided models, the first glass panel to be
removed is the one which is not touching a gasketed edge. This
panel is marked
1
in Figure 71.
•
On Lucius models with three glass panels the small panel is
1
.
•
On all Trisore and Bidore models the large panel is
1
. A Trisore 95
is shown as an example in Figure 71.
•
On all other models the order does not matter.
Note: Some models have two sizes of glass clamps; a two-bolt clamp
and a one-bolt clamp. Figure 72 shows the two-bolt clamp.
BEFORE YOU BEGIN
Figure 71
Side Trim
Bottom Trim
1
Figure 72
Two-bolt
Glass Clamp
Retaining Bolt
