2
2 Scope of Delivery
3 Mounting
•
Disassemble the upper part of the distributor completely, i.e. remove contact breaker,
breaker plate, advance unit, weights, springs, capacitor etc. Whether also the shaft will be
removed on that instance for the control and cleaning, must be decided on the condition
of the distributor. However, should be the axial play greater than 0.5mm, the work is
recommend to compensate the play with shims.
•
Put the driver sleeve onto the shaft and tighten it with the set screws (+ medium strength
thread lock).
•
Put the sensor unit into the case and secure it with the clip screws (+clips).
•
Put the magnet disk onto the sleeve and mount the distributor in the crankcase. The gear
position doesn’t matter and can be ignored.
•
Fit the grommet in the existing larger opening and lead the sensor cable from the inside
to the outside.
After adjusting the cap serves as the perfect dummy. The ignition cables are ending at
the frame.
