10. THE SEQUENCER
32
LEN
Sets the duration of the retrig velocity curve in fractions of, or rational or integer multiples of, a step
(0,125–INF). 1/16 is the nominal length of one step. This setting affects the behavior of the velocity curve
by defining the boundaries of its envelope.
VEL
Sets the velocity curve fade out/fade in of the retrig (-128–127). -128 corresponds to a complete
fade out during the set length, -64 fades out to half the velocity during the set length, 0 equals a flat
velocity curve with no fade, 64 fades into half velocity during the set length and 127 fades in completely
to full velocity during the set length.
10.5 PATTERN MENU
Use the PATTERN menu to perform pattern management. Press
[PATTERN MENU]
to open the menu. Use
the
[UP]
and
[DOWN]
arrow keys to move between the options. Press
[YES]
to confirm your selection. Exit
the menu by pressing
[NO]
.
10.5.1 RENAME
Opens a NAMING screen where you can rename the active pattern.
10.5.2 CLEAR
• WHOLE PATTERN
Clears the active pattern’s sequencer data and kit. A prompt appears when you
select this option. Press
[YES]
to clear, or
[NO]
to cancel the operation. Note that no pattern informa-
tion will be permanently lost until the pattern is saved to the same pattern slot that it was loaded from.
• KIT DATA
Clears the active pattern’s kit. All sequencer data will remain unchanged. A prompt ap-
pears when you select this option. Press
[YES]
to clear, or
[NO]
to cancel the operation. Note that no
kit information will be permanently lost until the pattern is saved to the same pattern slot that it was
loaded from.
• SEQUENCE DATA
Clears the active pattern’s sequence data. All Sounds will remain unchanged. A
prompt appears when you select this option. Press
[YES]
to clear, or
[NO]
to cancel the operation.
Note that no sequencer information are permanently lost until the pattern is saved to the same pattern
slot it was loaded from.
10.5.3 SAVE TO PROJ
You must have saved the project at least once before you can save pattern information.
• WHOLE PATTERN
Saves the active pattern’s sequence data and kit to the +Drive. A prompt appears
when you select this option. Press
[YES]
to save, or
[NO]
to cancel the operation.
• KIT DATA
Saves the active pattern’s kit to the +Drive. A prompt appears when you select this option.
Press
[YES]
to save, or
[NO]
to cancel the operation.
• SEQUENCE DATA
Saves the active pattern’s sequence data to the +Drive. A prompt appears when
you select this option. Press
[YES]
to save, or
[NO]
to cancel the operation.
10.5.4 RELOAD FROM PROJ
You must have saved the pattern at least once before you can reload pattern information.
• WHOLE PATTERN
Reloads the active pattern’s sequence data and kit from the +Drive. A prompt will
appear when you select this option. Press
[YES]
to reload, or
[NO]
to cancel the operation.
• KIT DATA
Reloads the active pattern’s kit from the +Drive. A prompt appears when you select this
option. Press
[YES]
to reload, or
[NO]
to cancel the operation.
• SEQUENCE DATA
Reloads the active pattern’s all sequence data from the +Drive. A prompt appears
when you select this option. Press
[YES]
to reload, or
[NO]
to cancel the operation.
10.5.5 IMPORT/EXPORT
Here you can manage the Sounds on the Digitakt.
Summary of Contents for Digitakt
Page 1: ...Digitakt User Manual...
Page 84: ...4116ENG O...
