Elektro-Automatik 06230304, Operating Manual

Page: 144 / 178

Page 54
PSI 9000 2U Series
www.elektroautomatik.de
ea1974@elektroautomatik.de
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
3.4.3 Remote control via a digital interface
3.4.3.1 Selecting an interface
The device supports, in addition to the built-in USB port, the following optional interface modules for user preference:
Short ID Art. nr. Type Ports Description*
IF-AB-CANO 35400100 CANopen
1 CANopen slave with generic EDS
IF-AB-RS232 35400101 RS232 1 Standard RS232, serial
IF-AB-PBUS 35400103
Profibus 1 Profibus DP-V1 slave
IF-AB-ETH1P 35400104 Ethernet
1 Ethernet TCP
IF-AB-PNET1P 35400105
ProfiNet 1 Profinet DP-V1 slave
IF-AB-DNET 35400106 Devicenet 1 Full Devicenet slave
IF-AB-MBUS 35400107 ModBus TCP 1
ModBus-Protocol via Ethernet
IF-AB-ETH2P 35400108 Ethernet
2 Ethernet TCP, with switch
IF-AB-MBUS2P 35400109 ModBus TCP 2
ModBus-Protocol via Ethernet
IF-AB-PNET2P 35400110
ProfiNet 2 Profinet DP-V1 slave, with switch
* For technical details of the various modules see the extra documentation “Programming Guide Modbus & SCPI”
3.4.3.2 General
One of the plug-in and retrofittable modules listed in 3.4.3.1 can be installed. It can take over remote control of
the device alternatively to the built-in USB type B on the back side or analog interface. For installation see section
„1.10.8. Interface module slot“
and separate documentation.
The modules require little or no settings for operation and can be directly used with their default configuration. All
specific settings will be permanently stored such that, after changeover between the various models, no recon -
figuration will be necessary.
Via the digital interface primarily the set values (voltage, current, power) and device conditions can be set and
monitored. Furthermore, depending on the interface module used, various other functions are supported as de-
scribed in separate programming documentation.
Changing to remote control will retain the last set values for the device until these are changed. Thus a simple
voltage control by setting a target value is possible without changing any other values.
3.4.3.3 Programming
Programming details for the interfaces, the communication protocols etc. are to be found in the documentation
“Programming Guide ModBus & SCPI“ which is supplied on the included CD or which is available as download
from the manufacturer’s website.