2 MHz LCR Meter Kit AU2019 Assembly Manual
●
10
Position the front panel on this board and secure it with 4 x 4 mm
countersunk screws, then tighten the nuts.
4 mm
M3 (Prevailing Torque
Type Hex Thin Nut)
Front Panel
6 mm standoff MF
Display PCB
14a. Mounting of the M3 male-female standoffs.
14b. Positioning the front panel on this Display board.
Mount the knob on the rotary encoder shaft and connect the flatcable
to J1 on the Display board. Slide the MCU board between the first two
guide rails counting from the bottom of the case, with the front panel
slid in its own guides. Then connect the second header of the flatcable
to J14 on the MCU board.
Note:
The hole in the bottom of the case must be on the side of J14.