Notice:
If you need technical support please contact us at
Please keep the Saturn 2 3D printer and its accessories out of the reach of children.
When you use the printer for the first time, you would need to level it refer to the leveling
tutorial before printing.
If the printing failed, you would have to clean the resin tank and change resin otherwise it may
cause damage to your printer.
Please fill 1/3 of the resin tank only and don’t over fill.
Please use 95% (or higher) ethyl alcohol or isopropyl alcohol to wash your model unless
you are using water washable resin.
Please use the printer indoors and avoid direct sunlight and dusty environment.
Please keep your printer away from water and dump environment.
Please wear a mask or gloves before using and avoid direct skin contact.
Please don’t disassemble the Saturn 2 3D printer by yourself, which will cause
your warranty expired.
If the FEP of resin tank is white or high printing failure rate,
please replace the FEP release film in time.
If you run into emergency issues, please shut down the power of the printer first,
and if you have any problems with the printer, please contact us at
.
