3.
Since the distance between the build platform and the screen will be changed during the
process of tightening the screws of the build platform, if you find that the leveling card of
Saturn 2 can be pulled out with no resistance, please click the "down" button (step value is 0.1mm)
until there is slight resistance to pull out the Saturn 2 leveling card.
(See Picture 4)
If you find the resistance of pulling out the Saturn 2 leveling card is too high,
please click the "up" button (step value is 0.1mm) until the Saturn 2 leveling card can be
pulled out with slight resistance.
(See Picture 5)
4.
After finishing the above leveling, set the current position of Z-axis as the initial height of the
first printing layer. The operation is as follows: Return to the previous interface and
click "Set Z = 0". At this time, a message will pop up on the screen as shown in the picture.
Then click "confirm" to finish.
(Note: "Set Z=0" only takes effect in print file mode.)
（See Picture 6）
（Picture 4）
（Picture 5）
（Picture 6）
1.00mm
10.00mm
1.00mm
10.00mm
0.10mm
0.10mm
This reset the Z-zero
position,continue?
Confirm
Cancel
