Guangzhou Electway Technology Co., Ltd.
www.electway.net
8.Using procedure and instruction
1
）
Prepare and check before charging
1.Do not knocked down the wooden packing with violence after received the charger,in order to
avoid damaging the machine.Check the charger if there is any damaged.It is prohibited to use if
there is any breakage.
2.Check the charger if there is any damaged between the AC input cable and DC output cable also
check the connection of the charger.Please stop to use if there is any dangerous condition.
3.Read this operation manual carefully.Confirm the model of the charger is matching the electric
car.
4.Meet the operating condition and demand of the third section of this manual.Check the charger
around 12~20cm whether there is anything block the charger’s air duct.Ensure the charger in a
ventilation and heat dissipation condition.Avoid using work in direct sunlight, high
temperature,rain,splash,snow condition etc.
5.Put the charger in the safe place,both put it in the car (included the car boot)and on the ground
directly are prohibited.
6.Put the input switch MCB is “off”
7.Put the charger connector and vehicle battery socket to disconnect
8. Connect the input interface AC 3-phase 5 line input,(ensure to connect the grounding wire).To
connect the aerial socket can check the 4-1for reference.Be sure to according to the serial number
splice,for example 1 corresponding
（〨）
.Screw the related locking ring after plugged.
9. Put the input interface MCB is “ON”
10.Plug in the DC connector (as picture 2-1),and then plug the charger connector into quick charge
socket.Ensure the charger connector and car charging socket is firm and reliable connection.
2
）
Starting charging
11.After pluging the charging gun, click on 'start charging' button. In 10 seconds, the
communication is successful and it starts charging.
a) If the display shows fault code ‘OX**’, please refer Appendix A (fault codes) to find the
reason.
b) If the module, digital tube shows fault code ‘OX**’, please refer Appendix B (fault codes)
to find the reason.
3
）
Charging
12. Clicking on the "Settings" button to switch the display interface and set up the charging
current. According to the battery management system (BMS), this charger provides the demand
for battery voltage. The battery is charged automatically without any manual operation.
13.The electric car is stopped using during charging, and the power should be switched off. Some
car models need to open the dashboard to start charging
14. Please make sure that the connection of gun and vehicle battery
charging socket is firm and reliable. During charging, plugging the
charging gun is not allowed. Disconnecting AC input cable and DC output
cable directly are not allowed. Dragging the charger cable, touching and
moving the charger is forbidden.
11
