Electrotherm Shenpaz Gemini LT, User Manual, Page: 17 / 81

Gemini LT user manual version 1.3.18 18 | P a g e
In order to edit the program name, press number "5" + ENT in the menu
Entering a new program name by means of the Numeric keys. To switch the numbers on the
screen to corresponding letter, use the up/down arrows . The Numeric keys will correspond
to the letters that appear on the display screen.
Editing an existing program name, using the right/left arrows selects the place to edit.
The cursor shifts position by means of the arrow keys.
The left CYCLE key is used to shift between the upper and lower case.
Editing the Program Contents
1. Press the arrow keys to select the characters.
2. Press the numeric keys to enter the characters.
3. To edit further characters, follow the steps 1 and 2 above.
4. Press ENTER to confirm.
5. C
OPY PROGRAM
:
to copy program from one to another follow the instruction on the screen press enter
all the program with the name and all the parameter will be copied
6. P
OWER SAVE
:
The Temperature will be reached after the time preset and the door will be closing to maintain
temperature in the furnace close
7. F
OR
G
EMINI
LT PRESS
VERSION ONLY
The Gemini LT Press is a press able version of the Gemini LT.
The programs from 200 to 249 can be programmed for press cycle.
ShenPaz is supplying a full into kit of pressing cylinder and plunger according to all ingots on
the market.
The press cycle can be programmed easily with 6 parameters
1- Start Temp
2- Heat rate
3- High Temp
4- Temp delay
5- Press delay
6- Cooling time